-
Please help me writing a small arduino sketch that monitors the voltage of the battery connected to the bpi-leaf-s3.
I'd like to see he voltage on a small oled and when the voltage is below a certain…
-
I would like to power the SIM800C AXP192 through the back board connector. Unfortunatly, it doesn't work : the baord starts and turn off after a few seconds. I tried to press the reset button without …
-
I cloned the repository onto my harddisk, copied config_T-DisplayS3 to config and did a make.
After a while the compilation ended with this error message:
Added the following directories to PATH:
…
-
Greetings,
So I've been doing some experimenting with using the CCS811 with a deep sleep functionality and have been getting some odd results. Perhaps someone also has some experience and can help…
-
Dear Pawel,
I have just installed you OGN-tracker to work with my Stratux on a T-BEAM and that works fine from firmware.binary coming from new Stratux eu022.
I have then compiled the firmware with …
-
I do as in the instructions on the command line and get an unsatisfactory result. Is this really supposed to work?
My board is AI-thinker.
![compile error](https://github.com/rzeldent/esp32cam-rtsp…
-
Hi,
I have a T-Beam version T22_V07 (20180711).
GPS and LoRa work great, but I can't connect to a barometric sensor on either I2C bus - the device is not found on 1st I2C bus (2/13) nor 2nd I2C …
-
would it be possible to have the igate/digi function available on the tracker(both sw with the possibility to swich from tracker to iGate)? Heltec and TTGO
use case: I have the tracker in the car,…
-
I am using Aprsdroid to send the frames over Bluetooth using Lora32 v2.1 TNC. It works intermittently, as some of the frames are not appearing on the radio.
I've leveraged the built-in debug capabili…
sq2mo updated
1 month ago
-
Support for e-Ink and e-Paper displays, such as Shareware. Preliminary work for the low CO2 consumption version of CO2 Gadget.
Developing actively with the following boards and displays:
- Lilyg…