-
Say you want a wired switch/dimmer connected to some gpio to dim for example the "generic dimmable light". Is this possible?
-
**NOTE: This is not a support forum! For questions and support go here: https://www.letscontrolit.com/forum/viewforum.php?f=1**
### Steps to reproduce
Visit the Hardware or Advanced pages
Does …
-
I know you described here https://github.com/hallard/NodeMCU-Gateway#nodemcu-esp8266-gateway-goes-to-wemos-esp8266 that this doesn't have a LiPo connector due to size constraints. However, for true au…
-
Hi,
I tried to run the example on a Adafruit HUZZAH32 – ESP32 Feather Board and switched Serial and Serial1 for better debugging.
Sadly the example keeps crashing when calling VitoWifi.loop(); in …
-
Hi,
I want to use the U8x8 library with a 64x48 OLED shield for the Wemos Pro Mini. It looks like you already have this for the U8g2 library. Could you add it for the U8x8 library (or can I add it …
-
I have the WS2812 shield for Wemos D1 and have been trying to figure out if it's possible to control the state of the light (on/off, colour, blinking) via MQTT but have not being able to find any way …
-
In a future revision, I'd like to see the opportunity to wire D0 to RST for deep sleep with a jumper / solder bridge on the board. This would mean moving the WS2812 LED to another pin such as D16
-
Add support for the ESP8266 Wi-Fi module. An arduino core for the ESP8266 is available [here](https://github.com/esp8266/Arduino). Should be fairly straight forward to add Firmata support.
-
Hi,
I'm using Sonoff-Tasmota on Wemos D1 mini and would like to have more than 4 buttons connected to it. I see that number of buttons/switches is locked to 4, and I also see that this number is h…
-
Wemos DHT11 shield is 1-wire protocol and it's on PIN D4 that means it's PIN #2 in MicroPython but PIN #3 is being used.
d = dht.DHT11(machine.Pin(3))