-
Today, deCONZ lost connection to the RaspBee. The deCONZ GUI was on the initial device selection screen, and wouldn't connect to the RaspBee. I could quit deCONZ through the menu. After resetting t…
-
Hallo,
da ich mir nun einen Arduino Nano + 868Mhz gebaut habe,
so habe ich als ersten Versuch den FHT80TF-2 geloggt.
- Kontakt geöffnet
> 2017.08.22 14:02:09 4: sduino_USB0/msg READredu: MU;P…
-
My node is sending strange messages every time it sleeps and wakes up.
The offending messages, as seen in serial monitor are:
```
4765 TSF:MSG:SEND,242-242-0-0,s=255,c=3,t=32,pt=5,l=4,sg=0,ft=0,s…
-
I'm trying to receive messages via 868MHz. The only problem I'm facing is the checksum of the package.
To verify the checksum, I need to use bitwise operators (BXOR) which can be found in the bit(…
-
Hi, I'm working with an ov7670 and a Atxmega256a3u; could you please upload the libraries?
-
aktuelle Implementierung verwendet Register 0xF0 & 0xF1 um die Versions-Nr. der Hardware zu lesen.
Dabei werden 0x14 (868MHz) und 0x18 (433MHz) gelesen.
Eine ältere Revision benutzt die Register bas…
-
Hi,
It is possible to add reverse byte order (LSB) option for protocol Labels Value (not for all message) and Binary-coded decimal (BCD) for Display format?
And LSB option (checkbox near Apply d…
-
Hi Max.
Currently building a new RPi /Node-Red/RFXCOM for non critical alarms in my house.
I have the latest software, having built all from from scratch this week. I have set up an RFXTRX transce…
-
I'm using an im880b configured to OTAA mode. The join procedure works well but defaults to data rate SF7.
The state `DEVICE_STATE_JOIN` isn't a recurring state if join was unsuccessful.
Instead th…
rraks updated
6 years ago
-
Hello
Do you provide 915MHz communication?
And if so, how can you configure the lorank to 915MHz.
Kind regards,
Gilles Callebaut