-
Hi,
I'm using LabView to control GRBL v1.1 (downloaded the latest GRBL few days ago). Everything works like charm except that I spotted something which might be a glitch in the jog control. The bug …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I am really sorry if I am not in right place, but I am running out of options. I am not…
-
I configured the agent in the pool mode according to the installation and configuration steps in the official document, but used the simulated attacker to pass SSH root@ip Unable to access. The prompt…
-
Hi, thanks for this project! I'm trying to apply a JED file to a Xilinx XC9536XL CPLD.
Your code compiled nicely on MacOS Cantalina 10.15 (decked out with AVR compilers and hombrew stuff).
I've…
-
Hey guys,
Just wanted to get this on the list for grbl mega. Not sure how this would be done but it would be nice to have the capability to do threading with a grbl controlled lathe.
If this shoul…
tklus updated
3 years ago
-
Wed 15 Aug 2012 11:25:18 AM CEST
The macro expansion for wdt_enable() used for the ATtiny5/9/10/20/40 family refers to the WDCE bit, which doesn't exist. Any invocation of wdt_enable() will show this…
-
Hi,
I'm trying to get an i2c sensor (the BMP180 from Sparkfun) up and running for the past few days with the arduino environment. However, without any luck. On an arduino I get it up and running in …
-
I would switch to storing raw data, rather than strings.
There is probably a significant overhead in doing a string conversion, because you're implicitly calling itoa a bunch of times. You'd be bet…
-
put your comments or questions here
-
I have a Mayfly sketch that worked great two weeks ago, uploaded fine using VS Code and Platformio. Now, it compiles fine, but when I upload the sketch to the Mayfly I get the (typical) message below …