-
https://community.home-assistant.io/t/433mhz-infrared-ir-to-and-from-mqtt-on-esp8266/6779/187?u=1technophile
wifi state
mqtt connection
sending or receiving
-
Hallo, frist of all, thank you for your good work!
I have installed OpenMQTTGateway on an ESP32, to connect a Remotesensor (a 433MHZ Sensor with temperature and humidity) with Openhab.
![remot…
joe63 updated
6 years ago
-
Hello,
(sorry for bad english, I'm french)
If I use only ZgatewayRF, no problem.
But, if I use ZgatewayRF AND ZgatewayIR, I have a problem with IP address (in serial monitor):
``
OpenMQT…
-
2 feature requests for the RF Bridge
When the bridge recieves any rf it sends something like the following to the topic
tele/sonoffrfbridge/RESULT {"RfReceived":{"Sync":11560, "Low":320, "High":…
-
Is it possible to repeat X times an IR message other than Sony protocol?
It would be useful for example sending continuous "volume_up" to an amplifier.
Thanks.
-
Hi All,
Does anybody know's why the BLE on the ESP32 is not working anymore after a few hours. I need to turn off the power and power it again. Below the messages when it is not working anymore:
…
-
* OpenMQTTGateway version master
I have 2 gateways, creatively named OMG_001 and OMG_002, but when I send an IR broadcast command I send it to home/commands/IR_GC which both modules receive. That'…
-
-
Hi, what a great work !
It has easily allowed me to build a gateway between [cloudMqtt](https://www.cloudmqtt.com) (modifications in OpenMqttGateway.ino are needed for me, should I post them ?) and …
-
I am trying to get this going on an ESP32 but it is stuck in a reboot loop.
From the serial monitor:
```
Rebooting...
ets Jun 8 2016 00:22:57
rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH…