-
### Related area
Port
### Hardware specification
STM32H5
### Is your feature request related to a problem?
Is support for STM32H5 planned in future? Couldn't find any discussion in regards and wo…
-
Hi,
Sometimes, my cubiboard blocks in the startup and it's impossible to do anything, no shell, no ssh. I don't others choices that to disconnect the cubieboard from the power.
I have a cubieboard …
-
As discussed on ##linux-surface, hardware buttons on some Surfaces are not working. Reloading the button module works post-boot:
```
sudo modprobe -r soc_button_array
sudo modprobe soc_button_array…
-
## UPDATE
Check latest comment.
I found the problem. Previously for some reason I set `CONFIG_TINYUSB_CDC_COUNT` to 2 and then enable the MSC. Now if I set `CONFIG_TINYUSB_CDC_COUNT` to 1 and MS…
-
```
Current status for hub 6-1.2 [2109:0812 VIA Labs, Inc. USB3.0 Hub, USB 3.00, 4 ports, ppps]
Port 1: 0080 off
Port 2: 02a0 power 5gbps Rx.Detect
Port 3: 02a0 power 5gbps Rx.Detect
Port…
-
From the datasheet:
![image](https://github.com/rp-rs/rp-hal-boards/assets/8949910/3640589d-91c4-424e-a4fd-c9a0c9268bf1)
Which I think would translate to this in code:
```rust
let (mut pio,…
-
I have the following problem. I set the PDO values for PDO2 and PDO3 to 15V/3A and 20V/5A resp., using a modified version of Example2-SetParameters.ino:
`#include
#include
STUSB4500 usb;
dou…
-
I just assembled the board and followed the instructions to flash the device and get the desired speed of 40-50 MB/s - all good.
When connecting a usb device (mouse -> full speed) to the port I get…
-
I've accidentally overwritten the S90app file with the hostname file. I tried getting access through UART but no luck, I can read the logs but can't write into it. It loads fine until it loads the S90…
-
I have a KM1 data communication module hooked up to my solar Hot Water which I am keen to get working with HASS. What plans are there for this device to be supported in addition to the KM2? Extract f…