-
Hi Proddy!
I had some time tonight to do some investigation into setting the heating flow temp. I've got a Bosch Easy Control CT200 and when weather compensation is turned on it sets the heating f…
-
My boiler is Buderus Logamax GB062.
EMS-ESP won't send any telegram after boiler detection.
It seems the problem is this piece of code:
```
// check to see if its a Junkers Heatronic …
-
Hi Proddy,
awesome work, thanks a lot!
I have a question, my boiler is a junkers cerapur comfort TOP 30-3 but is automatically recognized as a Bosch condens 2500. Not a big problem in the end becaus…
-
When I enter devices:
```
These 2 EMS devices were detected:
Bosch Easy (DeviceID:0x02 ProductID:206 Version:01.08)
RC30/Nefit Moduline 400 (DeviceID:0x10 ProductID:78 Version:03.01)
```
W…
-
Hi again, it's higgers from issue #23 ;)
I've been following some of the issues around tx_mode2 and the revised code to read the EMS bus and have been hoping that the changes would allow telegrams …
-
Hi there,
I also started a wiki for my Buderus GB125 with EMS+.
Because I use another interface hardware I am actually only reading the bus.
Maybe there is something that helps here.
https://g…
Th3M3 updated
5 years ago
-
With the encouragement of @MichaelDvP in issue #270 I decided to try to commission my Bosch MM200 module.
In testing I had the module configured with the selector dials set to positions 1 and 2, an…
-
Running the latest dev with EMS+ / TX fixes my devices are found:
Junkers Cerapur ZSB 14-5C boiler recognized by autodetect as
Model Buderus Logamax U122 (DeviceID:0x08 ProductID:203 Version:02.0…
-
Hi,
It Should be nice to have write support on the nefit moduline 3000 (RC300/RC310) for setting the temperature
The all use the EMS+ protocol. Hoping to add support soon.
-
As of HA 0.96.0 this component does not work anymore due to major changes in the climate integration. Are there any plans to change this?