-
**Describe the bug**
I first used JDK 8 and set `-XX:+UseG1GC` option to run a program, and exported the GC log (I will provide the link to the log file later). Then, when using GCToolKit to parse th…
-
I captured raw data using the front end designed by myself. The RFIC is MAX2771. I have checked the B1I/B3I/L1_CA/E1B_C/E5a. All of these signals can obtain right PVT results using GNSS-SDR V0.0.15. …
-
Hello @hudbrog!
I noticed that gCodeViewer calculates wrong flow rate values. Also, it displays more items in the legend than needed! See the following small G-code file:
```
; generated by Slic3r …
-
### Is your feature request related to a problem?
1. Open Cura
2. Check Machine Settings for my Ender-6
M117 Print Starting...
M75 ; Start Print Timer and Engage Fil Sensor if USB Printing
M117…
-
>
> Dear Nibbels:
I copied the e3d-toolchanger-config in your project from github today. I found a problem during use?
My configuration is as follows:
Board: Duet 2 WiFi (2WiFi)
Firmware: Re…
-
I moved back to Slic3r after having used Cura for some time, and noticed a slightly different behavior when starting a print: with Cura the initial Z and XY moves are combined in a single command, whe…
-
hello
I use gcodetools derivative in inkscape to generate gocodes.
Sudently, using dot lines, it generates a lot of G3 paths with very large radius instead of just lines.
The result is like that :
…
-
On IntelliJ version:
`IntelliJ IDEA 2023.1.2 (Ultimate Edition)
Build #IU-231.9011.34, built on May 16, 2023
Licensed to Wolt Enterprises Oy / David Lino
You have a perpetual fallback license fo…
-
GRBL has some additional commands like $I or ? and some other idiosyncracies.
- [ ] Send replies to LightBurn when GRBL-specifig codes are received
- [ ] LB sometimes sends only X123 without G1 be…
-
Today I was prompted to update my IDE (PyCharm) to the current 2024.1 version and the plugin stopped working. Are there any plans to update it?
![image](https://github.com/alexadhy/tokyonight-jetbr…