-
Hey Mark,
i use your Version of Cura. I think your modifikations are really good and this Slicer benefits from these changes.
So i have the following Problem:
Cura won't generate a spirali…
-
Hello there. I see that you are serious about coomputer graphics programs on Gentoo. Do you know linuxcnc and could you try to write an ebuild?
Thank you.
-
I consider to switch from servo to stepper.
I have few questions related to g-code generation
…
-
Hello, i am trying to test under x86_64 platform using linuxcnc, some drives that i have up and running with a previous version of lcec using ARM platform (AMD Zynq ultrascale) but having some issues.…
-
Our install docs are not sufficiently clear about how you can run sim/uspace debs on vanilla kernels for simulating your gcode programs, but that's a useful and valuable way to run linuxcnc.
-
G code (this is a standard ISO G-code feature)
%
N0430 G01 X15.100 Z-7.742
**N0440 X12.700 Z-12.542
N0450 Z-43.151
N0460 X15.100 Z-45.551
N0470 X15.383 Z-45.834**
N0480 G00 X18.837 Z5.543
%
…
-
Hi,
I went through the issues and I found out, that you recently added support for A3 drives.
I have B3 drives which should be etherCAT wise similar if not the same as A3 drives.
Should I just go a…
-
-
Congrats for your Qtdragon :D
I'm using you qtdragon_hd
Issues:
-F2 key only do machine off and don't do machine ON.
-To execute mdi command have to press Enter Key (axis let start with…
-
## Here are the steps I follow to reproduce the issue:
1. Create a .hal file with "loadrt hal_gpio inputs= outputs=PIN..."
2. Start linuxcnc.
## This is what I expected to happen:
Start …