-
Attempting an initial run at using gqrx.
Stock GNU Radio works fine, and the output of hackrf_info looks fine:
>
> hackrf_info version: unknown
> libhackrf version: unknown (0.5)
> Found Hac…
-
Running gqrx on Mac OSX 2.9 results in hit and miss results.
Most times it results in a segmentation fault: 11
Sometimes it works sometimes it does not
Runs get_devices
Andrew
ghost updated
6 years ago
-
I used to use the `monitor` binary to write to GPIO pins (specifically, DIO0_P):
monitor 0x40000010 0x01 // set DIO0_P as output
monitor 0x40000018 0x01 // set DIO0_P HIGH
However, these …
-
Dear Pavel,
I would like to transfer digital data (at the output of an IP compiler) in vivado and send it into a textfile.
Do you have any idea to do that?
Thanks for your help.
-
Hi Pavel,
Question...I was wondering if your multi-band WSPR receiver/decoder could be converted into a multi-band FT8 receiver/decoder. I see you use 'wsprd' to decode captured audio. I think th…
-
Hi , CubicSDR is a nice project.
but when i use it on osx,I Executive Refresh ,it need 3-5 minutes.
os:10.12.6
cpu:1.2G
mem:8G
Is there anybody has the same problem?
-
Hello,
gqrx crashes when I start it, as shown below.
My configuration (a Pi Zero machine).
$ uname -a
Linux picam 4.9.59+ #1047 Sun Oct 29 11:47:10 GMT 2017 armv6l GNU/Linux
I have installed …
-
Running macOS Sierra (10.12.3), can't install gr-osmosdr:
Dave$ brew install gr-osmosdr --HEAD
==> Installing gr-osmosdr from andresv/gnuradio
==> Cloning git://git.osmocom.org/gr-osmosdr
Updati…
dam90 updated
7 years ago
-
Just curious, has GQRX support been deprecated? Also I have noticed the IMGs are now readonly and HPSDR will not open port 1001. Also I Would love to see native USB support for GQRX.
-
Then, the only way is to reboot the redpitaya. This can be quite annoying (by the way, this could be the reason why arroseur goes down from time to time).
I wonder if it could be avoided by prevent…