-
Hello everybody,
first of all thank you for this project.
**Introductional words**
I uses this project to set up a wlan access point for my parents who have a mobile home and are travelling t…
-
We make a 100Mb switch which we used with Pi 2's and Pi3's... Its a "Hat", based on Realtek RTL8306MB. We have shipped thousands of them with Pi3's. They are bulletproof.
Pi4 will not connect t…
-
I'm driving a 192x128 matrix, however, the RPI can only go up to 60 ~ 100hz when playing an animation.
Chinese controllers can achieve high refresh rates 960hz+, however, these cards do not provide…
-
On an RPi 4 running Raspbian Buster and Kernel 5.10.44-v7l+ I'm finding that if I enable I2S that it's breaking SPI0, this is apparent through trying to setup can0 (MCP251XFD driver) using ip link com…
-
I bought a new Raspberry Pi 2, a 8 GB memory card, and the [SX1272 LoRa shield](https://www.cooking-hacks.com/sx1272-lora-shield-for-raspberry-pi-868-mhz).
However I can't get your software to work o…
Limro updated
3 years ago
-
please someone help me.. i am using p3 104x52 one panel. with direct regular wiring on pi 4. but i have problem. first row to 8 leds to 52 copy the last led..
https://github.com/hzeller/rpi-rgb-le…
-
Having trouble getting CanBoot and klipper run on Manta M8P STM32G0B1 with CM4. Reset of the board gives me can0 interface, ~/CanBoot/scripts/flash_can.py -i can0 -q gives me the uuid (if I'm quick en…
-
Install script does not work on freshly loaded Raspbian. After install, pressing button on the remote just cuts power to the Pie after about 2 seconds without shutting it down.
-
I'm trying to compile the latest kernel from rpi, and its failing over the strangest of errors.
```
make[2]: *** No rule to make target '/nix/store/85v9wvi4giwm6ch4vzpfygsc76nrgkrw-linux-rpi-6.10.0-…
-
Hello @betourneyb,
I saw the issue you opened in the PPS-Client [HERE](https://github.com/rascol/PPS-Client/issues/2). I am also trying to setup a Raspberry Pi as a NTP server, and have some succe…