-
- I've created the hardware per the schematic (Arduino Nano, SD interface only)
- I have confirmed that (by jumpering CS on the sd card interface to D10 on that board temporarily) that the Nano can r…
-
**Describe the bug**
When syncing a tv show season or episode older than 1970, the sync process throws errors and slows to a crawl
**To Reproduce**
1. Within Jellyfin, edit the metadata of an e…
-
When creating or writing to a file, I don't see changes after calling `file.close()` until after I reset the board, for example, if I run this:
```
>>> f = open("0:/test.txt", "w")
>>> f.write("Hello…
-
I'm uploading firmware on linux debian trixie with VisualStudioCode.
This is the upload full output with the finale error...
Are there usatisfied dependencies???
I'm not sure...
-----
* Execu…
-
```
For some people, the chatpad control utility quits very shortly after
displaying the comand prompt. If one runs it from the command line, an error
may be shown near the bottom of the output mes…
-
### Expected behavior
skaffold render
```
apiVersion: v1
kind: Secret
metadata:
name: super-secret-secret
namespace: test
data:
password: c3VwZXJzZWN1cmVwYXNzd29yZA
---
apiVersion…
-
## Environment
- Development Kit: nodemcu-32-s2
- Kit version (for WroverKit/PicoKit/DevKitC): master
- Module or chip used: esp32s2
- IDF version (run ``git describe --tags`` to find it): v5.0…
-
Not sure if this is actually possible - but would be cool to have support for these containers.
-
### Describe the bug
Altitude sent by the FC to the transmitter over CRSF is off the scale or doesn't work at all. Before arming the absolute altitude is shown. Then just after arming it's resetted…
-
Does OpenOcean also support the Eltako TippFunk devices. I currently have many of these installed and would like to switch from FHEM to OpenOcean
TF61L Light Actuator (uses EEP N5-38-08)
TF61D …