-
Yesterday I got my BTT Pad 7 and tried for hours to get it to connect to my WIFI properly and stay connected for more than a few seconds: no chance!
As I've been an IT service technician since 1988…
-
with SB2240 after 20/30 minutes of printing I get the error 'tmc "extruder" reports error : GSTAT: 00000004 uv_cp=1 (undervoltage!)
(Ldo nema 14 pancake run_current: 0.65)
both motor and board are…
-
Dear All,
I'm using the SKR E3 DIP on my Ender 2, working all fine except for the display. It stays blank and I can't change it to a mini display. Could you please get some support for this?
-
Hi.
When trying to update my 3do nozzle cam i get the following message when using the update tool:
Stopping crowsnest service...
[sudo] password for *****:
Opening device: /dev/video10
3DO Cam…
-
Tried compiling the default file, and modified for my A10m. Neither will compile. Error no 2. File not found.
FileNotFoundError: [Errno 2] No such file or directory: 'C:\\Users\\snaps\\Documents\\…
-
when in touch mode, marlin mode keeps running in the background and still does stuff like autohome
[Video](https://photos.app.goo.gl/yoYsAdYmKDbeMRg59)
TFT35 E3 V2.0
-
Is this intentional? If so it would explain why I cannot get my screen do do anything after flashing the newest BTT-TFT35-E3-V3.0 firmware bin file.
-
@bigtreetech Is there any particular reason why we don't have any FREE output GPIO pins that are pulled LOW?
I am trying to use one of the GPIO pins with **SN74AHCT125N** and drive Addressable LEDs…
-
I am trying out grblHAL on an STM32F4Discovery board with a BigTreeTech TMC2209 v1.3 driver board. I noticed a significant discrepancy in the current measurements I was getting from running motors whe…
-
I have a consistent crash repro during print.
My printer is ender 3v2 with BIGTREETECH SKR MINI E3 V3.0 board.
Here is the gcode I use, when I print this around 1h 02m the app crash and print stop…
keefo updated
1 month ago