-
**Checklist**
- [x] I updated the card to the latest version available
- [x] I cleared the cache of my browser
- [x] I verified that I'm really running the lastest version in my browser console
- …
-
### What happened
I have configured a MQTT server and associated sensors in my moonraker configuration. However, the sensors do not receive data.
Symptoms:
- MQTT data is not displayed in the fro…
-
user trying to use a script, but it has dependencies that were never installed, or documented to be needed...
-
Using this machine as a torrent downloader with Transmission, Sonarr, Radarr, Jackett, etc. I know these programs are heavy on RAM, but oom-killer gets triggered even when memory usage is lower than 1…
-
Hi,
The previous "issue" write about "add altitude to Kalman filter".
Does the module already "adjust" lat & lon with Kalman filter ?
I try with a small GPS device (HiLetgo GY-NEO6MV2 NEO-6M GPS Fl…
-
- TerrariumPI version: 4.8.2 and 4.8.3
- RaspberryPI 4
- Kasa Smart Plug
System worked fine until I change the relay Power on time from 25 to 15 seconds and the settle time from 14400 to 108…
-
Establish Cluster Duck Protocol Network using example from their repository. This test will only involve the Heltec LoRa Wifi micro-controllers
If successful try implementing with actual sensor d…
-
The example below works fine until 50th frame count and than reset frame counter. ChirpStack Network Server gives frame counter reset or rollover error.
When I try it without deep sleep mode, it wor…
mofm updated
5 months ago
-
I'm still testing but may I found a workaround, to make PWM PID happen. The trick is to set the temperature higher or lower than the actual value to trigger the hysteresis.
Here is how I did it in …
-
I tried your code and I like the simplicity to display lot of data with very little effort. Now I do not use
Homie convention for my project but I will describe my project. Basically I have local s…