-
I was going to suggest this as a feature, however I found that the feature is in configuration_adv
I sometimes forget to turn on the fan before I turn on the extruder, as I am now using the fan port …
-
Problem occurs on multiple printers
1.1.0 RC7
MOTHERBOARD_RAMPS_13_EFB or MOTHERBOARD_RAMBO
SDSUPPORT
REPRAP_DISCOUNT_SMART_CONTROLLER
Lcd blank, unresponsive to serial after power on between boot sc…
-
-
### 请确保您已阅读以上注意事项，并勾选下方的确认框。
- [X] 我已经仔细阅读上述教程和 ["提问前需知"](https://github.com/Mrs4s/go-cqhttp/issues/633)
- [X] 我已经使用 dev 分支版本测试过，问题依旧存在。
- [X] 我已经在 [Issue Tracker](……/) 中找过我要提出的问题，没有找到相同问题的ISSUE。
- […
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
I Have a Genuine Mega2560 powered 3dprinter using TMC2209's in UART mode on an RAMPS1.4 EFB setup. I…
-
这个版本的efb现在登录不上啊，请教怎么自己制作efb镜像，系统是mac。 自己动手丰衣足食。
fucao updated
2 years ago
-
Pin_MKS_GEN_13.h redirects to pins_ramps_14_EFB.h which redirects to pins_ramps_14.h
Here Z1 is defined as 46,48,62, and E1 (EXTRUDER #2) as 30,36,34 on MkS GEN v1.3 PCB E1 is labeled Z2 for th…
-
When making Marlin, this error is shown before stopping:
> make: **\* No rule to make target '/home/andy/tmp/wiring.o', needed by '/home/andy/tmp/Marlin.elf'. Stop.
Some suggest there might be an i…
-
When I try to use Marlin on my RAMPS 1.4 EFB with the MAX31855 thermocouple board and the thermocouple after compiling and uploading, Marlin goes into some kind of loop and I can't connect with pronte…
-
I have tried copying the proper board from boards.h as well as the old method of "43" but every time I have tried to verify I get the following error.
exit status 1
#error "unknown CPU"
I am un…