-
### Version
2.3.3
### Operating system type + version
Windows 10
### 3D printer brand / version + firmware version (if known)
Kingroon KP3s, Marlin 2.???
### Behavior
* The behavior of th…
-
I have purchased 2 spider 1.0 boards, both having the same 3.3v issue with stepper drivers plugged in. Initially, I could not figure out why the SD would not flash with a firmware.bin in the root dire…
-
There are now 5 device entries for the Onyx. One isn't spelled correctly, one has the wrong sensor, etc, and this should be cleaned up. Website portal does not seem to have capability to do this. T…
-
### The problem
I have my octoprint root directory at `/etc/octoprint`. Restoring from a backup fails because the octoprint user doesn't have permission to create files in `/etc` which is expected be…
-
Hey Daniel,
So Just reflashed to see if anything got better with the project and seemed good till, I powered on and my display flashed throttle error 5... when I disconnect to reconnect my throttle…
-
The number of works using Unicorn is rising. This Wiki page keeps tracks of research papers that rely on our framework.
https://github.com/unicorn-engine/unicorn/wiki/Papers-use-Unicorn-emulator
…
-
TL;DR It is impossible without workarounds to enabled OLED on the MPPT 2420 LC due to insufficient RAM. Question is if and how to integrate these workarounds into the official setup
When updating …
-
**Description**
File analysis of encrypted .ctb fails to "get end byte offset by layer" and printing status fails to show layer progress. API returns 500 and log as shown below. Problem is probably i…
-
Hi,
I have an Xtensa binary which uses LITBASE (special register #5). Without honoring it l32r instructions will always point to the wrong target address. Here is a relevant section from the refere…
-
## Version of the custom_component
v5.0.3
Firmware: 9.5.31
Hardware: 9.0.0
## Configuration
Sensor_protocol http
## Describe the bug
I use 2 MSS315 to measure my solar and/or batter…
Fyr42 updated
1 month ago