-
Hello!
I recently went back to Klipper after messing around with RepRapFirmware and Marlin. I successfully installed Klipper (using KIAUH) and got started with the configuration. I successfully…
-
Hello!
I just installed klipper and configured the basics. After trying out the M600 macro found on the klipper page i get a "move out off range" problem (Move out of range: 239.167 236.110 1.400…
izi96 updated
2 years ago
-
I'm trying to install klipper onto me ender 3 alongside octopi. Following the install process I get the the flashing portion where the guide states to run the comman `sudo service klipper stop` which …
-
FYI:
https://github.com/Klipper3d/klipper/pull/4977
-
Numpy is needed to do adxl345 measurements, but it is not installed by default.
A worksround is tun run:
`/home/debian/klippy-env/bin/pip install numpy`
-
Hello,
i am using an Ender3v2 with the 4.2.2 mainboard. I upgraded the fanduct to use two 4020 Sunon Meglever fans.
Also i use fluidd on an Raspberry 3b+.
My Problem is now that the fan stop …
-
I've configured the board with STM32F103, 20KiB bootloader, 8MHz crystal and Serial (on USART1 PA10/PA9). After flashing, the serial port appears:
```
pi@octopi:~/klipper $ ls /dev/serial/by-id/*
…
-
### Linux Distribution
Mainsail os
### What happened
Someone walked me through the Kiauh install twice and as of the latest update, it is unstable. Superslicer was unable to start prints, and I was…
-
Hello all,
I've done the MCU firmware upgrade on the printer before. Its resolved the MCU and host miss match each time. However, this time it isn't working. I just upgraded to the latest version …
-
### Browser
Firefox
### Device
Desktop PC
### Operating System
Linux
### What happened
I updated my Voron printer configured with fluidd. It was working right before the update. Last time I upd…
mootw updated
2 years ago