-
I have just connected the Pijuice hat with default battery. After installation of the software (using the GUI) it showed "communication error"
At first I noticed that the i2c address was not showi…
-
My code is blinking, how can I remove this blinking.
this is my code
import json
from samplebase import SampleBase
from rgbmatrix import graphics
import RPi.GPIO as GPIO
import time
import sy…
-
- **Etcher version:** All since commit 9b82891abb86fc27c3df531fa6e1086192de4f03 from @zvin
- **Operating system and architecture:** macOS (but possibly Linux as well, I don't it on desktop platforms…
-
Please excuse my ignorance on such matters but all documentation/training uses pins labelled GPIO and not BCM. So while the site is excellent the labelling is confusing and I teach this to people. Can…
-
*Note: It was confusing me trying to keep the [pi-wake-on-rtc questions](https://github.com/bablokb/pi-wake-on-rtc/issues/2) separated from the references to this repo - I'll try to keep my questions …
-
I just got my Caribou Lite (6GHZ R2.8) from mouser. I am having issues getting it working. I just want to verify that there should be no components soldered in the "MXR IN" box on the top of the uni…
-
The RPI pins that are used by the Codec Zero for are not listed in its documentation and makes it hard to know if it will work with other RPI hats. https://www.raspberrypi.com/documentation/accessorie…
-
Dear community,
I try to get and set values but I am unable to identify the correct adresses.
Requesting the type via telnet gives me : 204B. (Request via 00F8 / Protocol = P300)
After having d…
-
Hi there
How can I get the sense HAT working with increased I2C baud rate?
I started with an inverted pendulum project were I have a RPI 3 B+, a RPI sense HAT and an Adafruit Motor HAT. I stacke…
-
Audio started. ALSA, hw:audioinjectoris, 16-bit little-endian, 48000, 32x4, in: 1/2, out: 2/2
expected 24 bit/audio