-
```
If the stepper doesn't complete a full resolution or goes for long periods of
time between steps or steps over a long period of time, it gets really hot
due to a bug in the stepper code. It leav…
-
```
If the stepper doesn't complete a full resolution or goes for long periods of
time between steps or steps over a long period of time, it gets really hot
due to a bug in the stepper code. It leav…
-
```
If the stepper doesn't complete a full resolution or goes for long periods of
time between steps or steps over a long period of time, it gets really hot
due to a bug in the stepper code. It leav…
-
```
If the stepper doesn't complete a full resolution or goes for long periods of
time between steps or steps over a long period of time, it gets really hot
due to a bug in the stepper code. It leav…
-
Подключить контроллер и выполнить на нем команду управления
-
When I try to post a turning program from Fusion360 with the buildbotics post it says turning is not supported.
-
Can I holding the stepper to prevent slip after a gcode seeding. I need keep the stepper holding for a moment but when the system executed the gcode the stepper can be moved easily. So, can I send any…
-
I have a Chinese laser cutter with an AC motor like this that controls the up and down movement of the bed.
![](https://ae01.alicdn.com/kf/HTB1p1GAXAH0gK0jSZFNq6xMqXXa5/220V-AC-Synchronous-Gear-Mo…
-
To prevent dangerously high LC spikes, Pololu recommends placing a 100uF capacitor across the rails of each driver, as [outlined here](http://www.pololu.com/docs/0J16/5).
Currently, a single 100uF ca…
-
Hi all,
I would like to run Nema 23 4.2ah stepper motor with the octopus, but their are not movign at all...
Unfortunately I have not found any specific instruction on the wiring nor the coding pa…