-
Hi
I installed pothos, pothosaudio, pothosblocks, pothoscomms, pothosgui, pothosplottrs, pothospython, pothossdr, pothoswidgets, soapysdr and soapyrtlsdr on my MacBook.
When I run "PothosGui", it give…
-
- The meter canvases now support mouse wheel but haven't been calibrated to their ranges
- The manual gain sliders don't support mouse wheel yet.
Reference: #309
PR: #355
-
As an old shortwave DXer I really miss the tuning knob which would allow me to slowly tune across the spectrum without even looking at the radio.
I’ve tried to use the trackpad on my Macbook Air by h…
-
Thanks for providing an [AppImage](http://appimage.org/). Makes testing this application on Linux a joy.
Here are some minor suggestions for further improvement:
As you might be aware, the AppImage …
-
So I'm a newbie at building projects like these. I'm probably screwing something up..
First, following the wiki build instructions leads to an error. The cake step in CubicSDR fails with this:
CMak…
-
Looks like something goes wrong with in gr-fcd even with a fix for issue #357
csete updated
8 years ago
-
I've tried to install this CubicSDR on my armhf board because this seemed to be the simplest to install. Well, everything went fine until I've started to compile the CubicSDR itself. make says this:
…
-
I'm not sure if that's an issue in soapy remote, or just strange parameters, but I can't seem to get more than 1Msps without stutter. Some information:
Transferring RPi -> linux over wifi.
IPerf says…
-
Use case: Two connections to the radio, CubicSDR and HAM Logging program. Both using separate serial ports. When i change the frequency using CubicSDR the HAM Logging software follows the frequency ch…
ghost updated
8 years ago
-
Charles, do you have a PayPal account for donations or can we help in other way? Appreciate all your hard work on this software - quite a task doing it all alone. Anything at all, hardware, other stuf…