-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
Given XML file:
```
...
Tiberius
Tiberius
```
The following if-condition is not recognized as fulfilled for the two text-nodex "Tiberius":
```
if ($node/following::tei:…
-
We'd like to be able to use the built in autoconnect feature used by XCTU in our code. The following is the signal log for the two XBee units that were autoconnected through XCTU.
02-10-2018 11:50:…
-
```
What steps will reproduce the problem?
1. Receiving a 64-bit addressed I/O sample from a Series 1 XBee,
configured with digital channels 0-2 set to digital in, channel 2 set to
analog in, and ch…
-
```
What steps will reproduce the problem?
1.Trying to read some analog valeu with the getAnalog() function
What is the expected output? What do you see instead?
The output that appears is like this …
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
## Feature
Currently the addressable LEDs are bit-banged with software SPI. Ideally we'd like to support HW SPI2 so that we can do fancy things like DMA control of the LEDs. To enable that, we'll…