-
```
What steps will reproduce the problem?
1. Connect to a tcp slave modbus device with a non infinite read timeout
TCPClient (to test I connect to a tcp terminal, so that is no response to
queries)…
-
```
What steps will reproduce the problem?
1. Connect to a tcp slave modbus device with a non infinite read timeout
TCPClient (to test I connect to a tcp terminal, so that is no response to
queries)…
-
My setup is two KH10.5 wired in parallel (master/slave enabled) and connected to full stacks of HV2600 8* batteries per inverter.
The inverter and batteries are all on the very latest firmware using …
-
```
What steps will reproduce the problem?
1. All working fine --> data is retrieved from deivce, then...
2. The netowrk is disconnected (Unplug the network cable...)
3. A read attempt to the device f…
-
```
What steps will reproduce the problem?
1. All working fine --> data is retrieved from deivce, then...
2. The netowrk is disconnected (Unplug the network cable...)
3. A read attempt to the device f…
-
```
What steps will reproduce the problem?
1. All working fine --> data is retrieved from deivce, then...
2. The netowrk is disconnected (Unplug the network cable...)
3. A read attempt to the device f…
-
```
What steps will reproduce the problem?
1. All working fine --> data is retrieved from deivce, then...
2. The netowrk is disconnected (Unplug the network cable...)
3. A read attempt to the device f…
-
Hey buddy, how does this library work on pico?
-
Hi,
My application is to implement a Serial2 handler to run serial protocol like ModBus on ESP32. My another microcontroller is polling for reply from ESP32 with baud rate 38400. The time between t…
-
```
What steps will reproduce the problem?
1. Write a DataStoreWrittenToEventHandler that throws an exception on
erroneous input values
2. Register the event handler
3. Write erroneous input data via…