-
Are there plans to add windows 10 support. Can anyone point me in what do i need to do if not?
-
### What happened?
The docker crashes and, even after rebooting, it remains in error
### What did you expect to happen?
_No response_
### How to reproduce it (minimal and precise)
_No r…
-
See also: brianmcd/contextify#30.
For example, a home directory of `Brad Old` causes the build to fail:
```
> contextify@0.1.2 install /Users/Brad Old/Desktop/DEMO_jason/node_modules/d3/node_modules…
-
hi @Markus , I'm working on the 3d printer board which its serial pins connected to serial pin of ESP module. , in the module couple of html page store in its flash , these file send g-code lin…
-
### What happened?
I've running Zigbee2MQTT in a docker container on a x86 system. It works for a few weeks, but after a reboot I get the error
z2m: Error: Failed to connect to the adapter (Error: …
Joop9 updated
1 month ago
-
### Description of the issue
UI is not available: 502: Bad Gateway.
The log freezes with the below.
```
[12:37:38] INFO: Preparing to start...
[12:37:39] INFO: Socat enabled
[12:37:39] INFO:…
-
Run http://smoothieware.org/console-commands#config-get for the laser_module parameter (if true, its a laser) also could probably check for extruders if found, is a 3d Printer. Check for a Spindle co…
ghost updated
7 years ago
-
### What happened?
hi. After upgrading firmware to the newest version I'm facing problems with my zigbee2mqqt. It's randomly stopping and when I'm trying to start the addon it's cannot start. I have …
-
### What happened?
After updating to 1.36.1 all my hue wall switch modules (Philips 929003017102) show strange behavior:
- short press of button results in four actions: left_press, left_press_rel…
-
Hello, thanks for the update @max-christian I have upgraded from the COM IP to the SmartCom but this doesn't let me connect entering the IP.
If you're able to get this working with the SmartCom that …