-
Hello,
i have a NRF52832 Module without 32.768kHz X'tal and without DCDC.
But the Redbear examples doesn't work at all.
The Nordic Support said there are config headers which have to be changed t…
-
I propose breaking out a number of large tests from the unittests to their own test. This to decrease the flash size of the full unittest binary a bit.
## Tests:
Flash sizes as mentioned below a…
-
Adding the doc from last week's conversation with a few updates.
### Use Case
The intended use for this HIL is to focus on internal flash on SoCs. Prior discussions have sought solutions for any f…
-
See https://github.com/microbit-foundation/DAPLink-microbit/issues/119
It would appear that DAPLink versions that are identical apart from their version number yield different behaviour when datalo…
-
I've successfully compiled canokey-nrf52 firmware for my **Ebyte E104-BT5040U** and have **canokey.hex** and **canokey_flash.uf2** at hand . According to README, I should compile and flash **Adafruit_…
-
### Platform
NRF52, ESP32
### Description
Can the AHT20+BMP280 sensor be added to support. Currently just the humidity is NOT shown. Everything else seems to work.
https://www.aliexpress.com/ite…
-
### Platform
NRF52, ESP32
### Description
I'm not sure exactly what the behavior is at the moment for a HF node, will it pick up all HF messages (i.e. 868 and 915)? But certainly it is picking up 9…
-
### Platform
NRF52, ESP32, RP2040, Linux Native
### Description
We are currently not using the DOP value to throw out bad position values causing smart position to use a lot of airtime while the un…
-
I can not upload Sketchs to the Micro:bit v2 from a Macbook Air M1. It keeps saying the following error messsage:
Error: No Valid JTAG Interface Configured.
Arduino: 1.8.19 (Mac OS X), Board: …
-
### Platform
NRF52
### Description
right now we're only using low-level `sd_power_system_off()` for deep sleep and [it's not using the msecToWake parameter](https://github.com/meshtastic/firm…