-
The design runs in a single clock domain, driven by `clki`. This pin is a 48 MHz signal, and as a result the entire design actually runs at 48 MHz.
As a result, the system is overclocked and can fa…
-
I just mount this board with a mixing extruder, 2 Z stepper, switch endstop for X/Y and TOUCH'MI level bed sensor, but it was really hard to find how :
- to connect correctly the endstop (in the pino…
-
I have been using a Blackwidow Lite (2018) keyboard on Ubuntu 20.04 for the past 6 months without any issues. However, two days ago, the keyboard started randomly disconnecting after a certain period …
-
I've put my device into USB bootloader mode and I've previously installed libusb-win32 drivers via Zadig.
When I try to upload the firmware I get
```
>python -m ch55xtool -f .pio\build\ch559\…
-
Hi,
I have a Spider v2.2 that is not working. I have tried UART and USB connections on multiple raspberry pis and multiple linux machines. No usb device appears in lsusb. The board was functional a…
-
Hi!
Just tried to flash a Manta M8P (V2.0) with Katapult / Klipper. It uses a STM32H723 controller.
Compiling and flashing Katapult was no big deal. And since I enabled the Status LED I can see…
-
**Describe the issue**
REQUIRED -
A clear and concise description of what the issue is and what you have already tried to fix the issue.
**Screenshots**
REQUIRED -
Add screenshots of ALL the …
-
I have purchased 2 spider 1.0 boards, both having the same 3.3v issue with stepper drivers plugged in. Initially, I could not figure out why the SD would not flash with a firmware.bin in the root dire…
-
The dfc connected to garmin but not registering data. Tightened all wires connected and unconnected powered on and off. Do I need new dfc?
-
I recently purchased this adapter, ~~and was disappointed that it did not work out-of-the-box with retroarch: while 9 N64 buttons did get detected, 5 did not trigger any event.~~
~~I dug a bit, and…