-
**What's your question?**
I‘ve Setup your Plugin With my ws2812 Strip, Bit can‘t control them.
They only Lights white in Full Power.
I use a levelshifter „ TXS0108E“.
-
When trying to control two WS2812 strips with AdaFruit_NeoPixel on two separate PWM GPIOs (Board.D13 and Board.D18) I get the following RuntimeError:
Error in atexit._run_exitfuncs:
Traceback (mos…
-
Im looking into using this for my enclosure and i have a 6 pin LED strip on hand.
Does this work with a 6 pin Strip (R,G,B,White,Warm white) ? And how would i go about wiring it ?
-
Hi,
I have been trying to get this running for a few evenings now already without any success.
I must say though that I am still quite early in my python adventures and am still getting a bit confus…
-
I ran successful this plugin on a RPI3B and still works.
Switching to a RPI4 with minimal difference, LED dont turn on.
My question is, in what status should GPIO10 be in?
RPI3B - GPIO10 - 0V (se…
-
I am running into an install failure, which seems related to the node-gyp version being used.
## What's going wrong
When I run `npm install rpi-ws281x` I get the following output ([full output h…
ajmas updated
3 years ago
-
This is spun off #9617 to aggregate user feedback for another round of pip’s location backend switch from `distutils` to `sysconfig`. If you find yourself seeing something like:
```
WARNING: V…
-
**Description of the bug**
Fresh install of Octoprint 0.18.0, installed plugin and none of the LEDs light up in the strip. This strip works fine on a RPi3 with octoprint and also can be lit up with…
-
updated to Commits on Apr 28, 2021
Bitmaps not displaying after updating, leds are working with std LED effects like "sparkle"
LED Control Effect on drop down is also not displaying bitmaps
-
There are times when I'd just like the printer / print bed to be highly visible. Torch mode is perfect for that, but it's restricted to the timed torch mode settings that are pre-programmed. Personall…