-
Hi folks, I used rtl_433 a long while ago to get weather data in my neighborhood and it worked very well.
Today I am trying to use rtl_433 again but running into issues. As far as I can tell rtl_433 …
-
I improved the noise adding few caps to the Silicon Labs clock generator chip and now the standalone instrument is fully working up to 1.5GHz with only a very little residual noise above 1.4GHz that i…
-
I have built from master, and also used the latest release from github. I am using the source: `source=rtladsb-0:name=ADSB`
I am often running into the error:
```
SOURCEERROR Source ADSB has en…
-
This is not an issue maybe.
I replicated the Si4010 based circuit and dumped the hex code into IC. I'm using 10-pin variant of Si4010.
(Download sample codes from Si4010 page -> duplicated keyfob_…
-
Hi guys,
For a small project I ported an Arduino/Raspi library to control 433/315MHz devices (https://github.com/sui77/rc-switch) to golang/periph.io.
This is the initial version: https://github…
-
It would be nice if you could specify how much time to spend on each frequency. If sensor A at 315MHZ broadcast a signal over 3 seconds while sensor B on 433MHZ broadcast a signal in 3 burst over mil…
-
---- latest mayhem_nightly_n_230613_FIRMWARE. is making tpms app work only once , as you boot device up and open tpms app all works , however if you close the tpms app and reopen it it wont detect sig…
-
I've got 4 of those sensors on e-bay, but with slight protocol difference (FCC ID: MRXEG53MA4), and made some changes in the schraeder.c file after some captured signal observations and reading the fc…
-
### Describe the bug.
If you click “more info” on specifically the Tesla charge port opener saved Sub-GHz signal and then back out of the Sub-GHz App, the firmware will become unresponsive, requiri…
-
### Describe the enhancement you're suggesting.
I'm looking for the correct place to add new protocols/modulations as defaults. For example, my Mazda 3 uses +/- 50 FSK centered at 315MHz (I know I ca…