-
In #1792 @whosawhatsis writes:
_Bridges, especially "internal bridges" (first solid layer over sparse fill) should use the spacing of the infill pattern to determine how much anchoring length it need…
-
When running in GUI selection mode it would be nice if the initial selection could be set to the window outlines by just left clicking a window without dragging.
-
_From @1l0 on October 7, 2014 10:46_
A noob question.
To show just a rune by keyboard typing, this works fine,
[gist/rune.go](https://gist.github.com/1l0/a8af4a624c725d7fca55)
but when I attempt to s…
-
### Version
found and tested solutions for 2.3.0, but found for 2.4.0 alpha 3 as well
### Operating system type + version
Win10
### 3D printer brand / version + firmware version
Craftbot Flo…
-
It would make it a lot easier to integrate this with plotting packages.
-
**Describe the bug**
If a variable is defined with different incompatible units in different modules, this following error message comes up. The problem is that the error message says it's the 'val' …
-
There's been lots of discussion about our automatic range conversions, especially when it comes to `img_as_float`. (See for example #3009 and #3052.) In #3052 @stefanv suggested that we do an audit to…
-
Hi,
I've been using haussmeister to import RAW files into suite2p before and it is super useful. Thanks!
Recently after a re-install of the ThorImage software (both were ThorImage 4.0, 2019 vs 2…
-
fmt.Fprintf("%d", 8)
Since all interface data fields are now pointers, an int must be allocated and
initialized to 8 so that it can be put in an interface{} to pass to Fprintf.
Since we kn…
-
Hi.
I'm a graduate student studying about quantum physics in the master's degree.
And also I am a new beginner with using this pyprocar program.
But now, I faced some problems with plotting Fe…