-
```
AT+CIOBAUD=9600
```
Note: do NOT use `AT+IPR=9600` ~!
```
AT+UART_CUR
AT+UART_DEF
AT+UART_DEF=, , , ,
> AT+UART_DEF=115200, 8, 1, 0, 3
```
-
In the arduino sktech, there is the baud rate config for 115200
in all GUI and Atmel Studio project 57600.
=> Is the Arduino sketch really up to date?
Even if I change the baud rate, I get no mat…
-
### Describe the bug
I am trying to set the clock frequency of the i2c but unable to do so.
I have tried configuring the /boot/config.txt
```
dtparam=i2c_arm_baudrate=200000
```
When i reboo…
-
I've read in SAMD21 datasheet that the frequency generated for the I2C SCL line depends on the BAUD register.
Accoring to the documentation, this field should be generated using the following ecuat…
-
```
What steps will reproduce the problem?
1. Change baudrate on GPS/emulator
2. Compile and flash
3. Text is scrambled when sending data to OSD
What is the expected output? What do you see instead?
…
-
Hi, I'm facing the need to use a custom baudrate that is not listed in the settings' list.
Is there any option to add a custom baudrate in the list ? If not, would you please consider adding this pos…
-
Could you possibly compile a version with a lower baudrate (no more than 128000)? My USB to serial adapter can't handle much more but I can't compile this code. The I²C-bus I am trying to monitor also…
-
Hi,
first of all, thanks for making this driver open source. I'm pretty sure the robotics community appreciates it.
I have a question regarding the baudrate. I'm able to run my 3DM-GX4-25 without an…
-
I've build dunfell release
bitbake radxa-minimal-image
and connect terminal to UART2
at boot time there are garbage symbols
I connect oscilloscope and found bits duration about 660 ns, it is…
-
Is there any way to do so?
I'm able to change baudrate in the source code.
And say communication program to set specific baudrate (picocom).
But it seems 115200 is the only working setup.
It's…