-
Printing off the SD card, it paused indefinitely no matter how many times I pressed resume.
Used the same gcode file on the raspberry pi to print and it works.
The printer is Dovov S2. I used …
-
My Hotend RGB was working fine (I don't use it that much) but since a few days ago it starts on blue and stays there. I cant change it nor turn it off. I don't know what i've changed in my cfg or in m…
-
### Bug Description
Error message thrown: "STOP called because of BLTouch error - restart with M999" after starting G29.
### Steps to Reproduce
1. Build i3 Mega with standard build-volume, i3…
-
Initial marlin configuration has **Z_MIN_PROBE_PIN** and I don't see in manual what should it be. Currently my BlTouch doesn't work because of that I guess.
-
Hi, I have a Bigtreetech SKR v1.3 and 3D Touch but the 3D Touch doens't work. I've tested the 3dTouch using some code in an Arduino Mega and does work perfectly. I'm using Marling 2.0 and when it star…
-
I have a bltouch, TMC2130, neopixels all working with TFT35 v2.0 but i have found when leveling with bltouch my bed temp will not read but after probing it goes back to working.
-
Hi there, i already install the version 295c° with BL TOUCH (I USE A 3D TOUCH VERSION), It seems to work fine, but notice that the red light is always flashing, even when printing. The other problem i…
-
I try the following config on my catboat install on BTT PAD7 on a Kobra Max, with the MakerPanda board for Stealthburner.
[bltouch]
sensor_pin: !PB6
control_pin: PB7
pin_up_reports_not_triggered…
-
New BIGTREETECH-SKR-mini-E3/firmware/V2.0/firmware-bltouch-for-z-homing.bin after loading bin fill bltouch no longer works on startup bltouch doesn't run test
-
Hello all,
I purchased a S6 board (to replace my F6 board) and I would like to connect my BLtouch to the board. I unfortunately saw that the BLTtouch PWM connector should be connected to the Z-max …