-
I've spent some time gathering information on how to get the Manta M5P to use the CANBUS with a CB1.
I first flashed klipper to the EBB36 according to the instructions in the manual.
Connected are 2…
-
I am trying to connect esp32 with a flipsky vesc, but cannot get esp to work. I connected it only through UART because I do not have CAN bus transceiver.
-
-
Device response time is awful if the can stream contains lots of data.
My suggestion is that we may be able to use CAN filtering / masks as the mcp2515 chip supports hardware filtering of the can str…
-
What is the preferred way to wire the CAN bus when you have multiple devices? In my example I have the SB2209 tool head board connected to my pi via a U2C adapter. What order should the three devices …
-
I'm trying to find the place (CANbus code) to read the "fuel" gauge shown on the dashboard.
Is there a way to read this value?
(We already know how to read SoC.)
-
Manual flawed at pages 9, 10, 11
Expirienced the consequences 1st hand. Was not paying attention and destroyed my canbus board and the toolboard.
here is the problem:
![Screenshot 2023-12-20 0…
-
Leds controlled with canbus
-
Hi all,
I've been working on a system that needs to read the incoming Notifystate from the autopilot, and during my testing, I found out that the bitmask is misread by the GUI tool.
First, lets …
-
Does you design support the attachment and use of these CANBUS boards?