-
### What happened?
When trying to flash LAUNCHXL-CC26X2R1 with CC2652R_coordinator_2023050 firmware the "SmartRF Flah Programmer " Ver. 1.8.2. reports fault.
Re-flashing of my CC26X2R1 with the…
-
## What happened
Changing brightness of GL-SD-001 works, but command times out causing other changes to be queued.
Additionally, the updated brightness is not reported back to mqtt
## W…
-
### What happened?
trying to pair a Bosch TwinGuard smoke detector, as a Zigbee 3.0 device it needs an install code. The QR code of from device is:
`RB01SG0D836591B3CC0010000000000000000000000D6F0…
-
Hello :)
## What happened
After a day or two running perfectly fine, routers kind of disconnect from the network; trying to execute any command results in timeout.
It happens for all routers I ha…
-
### What happened?
When sending a lot of messages at once sometimes an error log message pops up and it seems like devices dont end up in the desired state.
Zigbee2MQTT:info 2023-07-30 15:11:29: …
-
### What happened?
Adding switch I get this error
Error 2023-03-30 07:22:00Failed to add from group (Command 0xa4c13890a3865400/1 genGroups.add({"groupid":1,"groupname":""}, {"sendWhen":"immediate",…
-
Request Z-Stack 3.x.0 Zigbee coordinator firmware with RTS / CTS Hardware Flow Control enabled and compatible with the new [Sonoff Zigbee 3.0 USB Dongle Plus adapter by ITead](https://github.com/Koenk…
-
### What happened?
when starting the addon, I receive following message
```
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
READ THIS CAREFULLY
Refusing to start because configura…
-
Hey Folks,
I was trying to download a firmware, but all of the time I'm getting the error the archive is corrupted.
https://github.com/Koenkk/Z-Stack-firmware/blob/Z-Stack_3.x.0_coordinator_202305…
-
### Link
http://www.futlight.com/light/xqy/fut089z.html
### Database entry
{"id":5,"type":"EndDevice","ieeeAddr":"0x540f57fffe0f3ebd","nwkAddr":7944,"manufId":4098,"manufName":"_TZ3000_xwh1e22x","p…