-
I've been talking with @Fragmon a bit about their Kobra work today and an interesting find came up: Bltouch probes don't work with the clock speed set to 200mhz. Flashing a 200mhz config shows a 168mh…
-
This isn't documented very well reguarding Marlin configurations. I acquired the Hurikan Configuration.h file to use as reference reguarding settings related to the probe and my printer wont even run …
-
I just installed the new creality V4.2.7 board on an ender 5 and I cannot get this sensor to work. I’ve watched every video I can find and changed my firmware correctly (based on what I’ve been told) …
-
Scenario:
Hardware:
RPI3, 4.14.22-v7+, /boot/.firmware_revision: v634741d4199871ab8bd5446a8e63b7e06c1885af (latest by today)
Device: 3D Printer, FTDI Fake Chip: FT232RL, 0403:6001, SerialNumber: …
-
### Did you test with a precompiled firmware?
Yes, problem fixed. printer boots fine.
### Bug Description
When compiling MRISCO Source from scratch, causes Ender 3 S1 to soft brick and bootlo…
-
I followed the steps, compiled firmware with Marlin 2.0 en flashed the SKR mini E3 v1.2 and everything works fine. Auto home, printing.
But when the bed or nozzle starts to heat up the menu starts …
-
Does it work also as a ZX80?
Here you can see a nice trick that will do with 4 resistors in case!
https://sinclairzxworld.com/viewtopic.php?t=1329
-
Am I wrong to think that this thing will work on a 4.2.2 board? For the life of me cant get this to work and my searches are not getting good results.
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I have a CR-10 S5 with a Creality mainboard v2.2. It runs on Marlin 2.1.2.3 with `BOARD_RAMPS…
-
As per the Klipper changelog (https://github.com/Klipper3d/klipper/blob/master/docs/Config_Changes.md), several options/features have been removed.
"20211102: Several deprecated features have been …