-
This is used by DJs to control lighting.
-
Hi @luksal , I tested your example, but it receives 0 randomly, I cross checked the data using logic analyser, the data is perfect but esp32 receives 0.
![WhatsApp Image 2021-09-15 at 3 28 57 PM](ht…
-
Remote control ESPixelStick effects using DMX --> E1.31
I think of something like https://github.com/Aircoookie/WLED/wiki/E1.31-DMX#3-effect
Actually it's possible to send RGB values for each pi…
-
### Checklist
- [X] I have filled out the template to the best of my ability.
- [X] This only contains 1 feature request (if you have multiple feature requests, open one feature request for each feat…
-
Have a couple of sites that make heavy use of pixel mapping and other media using sACN as it's protocol of choice over the network. Some of these controllers use a refresh rate at high as 60hz (FPS).…
-
Not to say it *ever* worked, so this is not new breakage.
I finally got some dmx hardware, specifically, the hardware mentioned here, because it is cheap:
https://artemis.forumchitchat.com/post/…
-
I tried to read the DMX data following the scheme inserted in the LXSAMD21DMX.h file on an Arduino M0 Pro and also on a MKR1000 but the incoming DMX value, also displayed on the Serial Monitor, contin…
-
On Linux, non-standard baud rates are often required, but not "supported" by traditional termios APIs.
They must be set with an IOCTL but this is still needed.
The DMX512 Lighting protocol, for…
-
Support _RDMNet_ using the new E1.33 protocol
See also: https://github.com/ETCLabs/RDMnet
-
- Robe - https://github.com/OpenLightingProject/rdm-app/pull/100#issuecomment-328076605
- [ ] ROBE_PT_FEED
- [ ] ROBE_PT_MODE
- [ ] ROBE_MIC_SENS
- [ ] ROBE_THEATRE_MODE
- [ ] ROBE_C_CA…