-
Hi Kristoff,
Have you thought about implementing an RX feature? I'm considering doing this for DapNET, as an alternative to commercial pagers...
Regards,
Manoel - ON6RF
-
### What happened?
On ESP32-C3 whit WLED V0.14.1-b3 - Flickering (ws2812) while using 2x PWM + ws2812 (using just 1x PWM + ws2812 works fine)
See here: https://youtu.be/Iuy7_qMrHKg?si=UGeykAd4Z1…
-
Not sure if this has been requested before, but would it be possible to add a secondary MQTT Host + Port to Tasmota?
If primary MQTT host fails, retry the secondary MQTT host.
Just a nice to hav…
-
Hi everyone
Anyone has luck with LED panel using [CHIPONE's 2153](https://olympianled.com/wp-content/uploads/2019/11/ICND2153_datasheet_EN_2019_V1.2.pdf).
I'm using this driving board: https://www…
-
ive tried with another pannel and they both do this so the panel is …
-
Hey, I have a Project for School and my 64x64 RGG LED-Matrix is not working properly (image)
We are using a Adafruit HAT with RTC
The command is: sudo ./demo -D 0 --led-rows=64 --led-cols=64 --led…
-
**Describe the bug**
**file v1.1_GRBL_coreXY_servo___.ino.standard.hex in release GRBL-Plotter-1.7.1.**0 seems to be based on v 0.9i of GRBL (not on v1.1h) as, when uploaded to the Arduino using Xlo…
-
Hello World!
-
I built a LED matrix cube using 6 64x64 LED panels, a Raspberry Pi 3B and a ElectroDragon "RGB LED Matrix Panel Drive Board".
I have connected 2 LED panels in each chain and then use all 3 chains.
…
-
### What happened?
AP comes up, but is not connectable with newest esp32c3dev.bin
### To Reproduce Bug
Flash newest esp32c3dev.bin to ESP32-C3 from https://github.com/Aircoookie/WLED/actions/runs/5…