-
Hello, I would like to know if you have any idea why when I load the grbl firmware, I leave the laser burning all the time, I work with an eleksmaker A3 pro, I used your software beforehand and it was…
-
hello, i want to know what i need to install along with the program ... libraries etc. thank you!
-
I found a big problem with your software, while more test points I assign(for example each 3mm), more unstable the calibration becomes...sometimes the tool does not even touch the pcb when it is etch…
-
So, in the news today, Eleksmaker, seems to have pulled some inspiration from LW3
```
if ( "Imitation is the sincerest form of flattery" == true ) {
console.log("LW is so famous even the Ch…
ghost updated
7 years ago
-
Software looks to be the one I need but, after I installed and run it, it only performs a few movements and then it stops while the laser remains on. I have to reset to make it work again but again, o…
-
Hello
I use grbl 1.1e
Today I tryed to cut a paper as in the demo-video. This mean that I use "Vectorize!" -Mode.
The result is a g-code in absolute coordinates.
When I send it to eleksmaner SE…
-
Hello,
I don't know if this is the right place but, I will try to ask anyway
I have been trying to make this "Laser Engraver" work with Laserweb3 http://www.ebay.com/itm/5-5W-30X40cm-Laser-Engr…
-
Motivated by https://plus.google.com/107113996668310536492/posts/4Y41g21bByK
In LW3 we had https://github.com/LaserWeb/LaserWeb3/blob/master/server.js#L506 and https://github.com/LaserWeb/LaserWeb3…
ghost updated
7 years ago