-
Dude, I'm sure you are doing some very intelligent stuff in this API, but I am dying here trying to _find out if an input pin is high or low_. :(
In some older or lower-level API, I would do stuff …
-
The timer traits available on the 0.2.x versions have been removed ahead of the 1.0.0 release. See: #357
This issue servers as a tracking issue until we add them back. The open (breaking) problems s…
-
Howdy!
I would like to use the DAC of the ESP32 in DMA mode. The dac.rs itself only supports direct writing to it but I guess that is fine for some use cases. According to the documentation in the …
Slamy updated
1 month ago
-
Most pin functions (`is_high()`, `set_low()`, etc.) return results, which are virtually always infallible, but we are still forced to unwrap them which is a very unfortunate and bad design smell.
I…
-
Hi,
I was trying to use this crate with a raspberry pi pico. I used it like that:
```Rust
let mut data_pin = pins.gpio15.into_mode::();
let mut cs_pin = pins.gpio13.into_mode::();
let mut sck_…
-
Various ESP32 models have an integrated temperature sensor that is supported by [esp-idf](https://github.com/espressif/esp-idf).
It would be nice to see support for that sensor built into this crate…
-
**Describe the set-up**
CubeIDE version: 1.13.0
STM32CubeF4 version: 1.27.1
custom board: STM32F407zgt6
PHY: LAN8720A
FREERTOS:10.3.1
CMSIS_V1 CMSIS_RTOS:1.02
**Describe the bug**
tcpip_t…
-
It looks like [embedded-hal v1.0.0](https://crates.io/crates/embedded-hal/versions) is approaching a release :tada: . Within a reasonable time frame after release (3 months? 12 months?) this crate sho…
-
I don't think we should spend time integrating NetBSD into the supported platforms. I just want to report that it works with these caveats:
a) use gmake instead of make (gnu make instead of bsd mak…
-
This is mentioned in https://github.com/rust-embedded/book/issues/246: what is the recommended way to share a `Delay`?
Currently all the `Delay` methods take a mutable self reference, e.g. `Delay::…