-
Replaced a V2 version with V3. All the fans are running and the house is nice and cool, so unless there is a new cooling requirement it should work. But what I get is after approx 30 min the print j…
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
7 months ago
-
### Cura Version
5.4.0
### Operating System
Windows 11
### Printer
ender3
### Reproduction steps
1. Open cura
2. Move to a second monitor
3. Maximize the window
4. Close cura
5. Reopen cura…
-
I have an skr 1.3 with TMC2208 V3.0. I only insert the jumpers on the Red UART pins.
No matter what I do I only get errors on standard commands like M122:
Send: M122
Recv: echo:Unknown command: …
-
Hello my display has T5L1 DGUS2 v4.3 2021.10.21. and by mistake I flashed with the T5L_UI_DGUS2_V45_20220105............. now what to do? the screen is black nothing even try to flashing with the 3.5 …
-
#### What were you doing?
Try to use TP-Link Tapo P100 (2 pack) with your plugin.
https://www.tp-link.com/en/home-networking/smart-plug/tapo-p100-(2-pack)/
#### What did you expect to happen?
Sw…
-
### Application Version
5.1.0
### Platform
Windows 10
### Printer
Creality Ender3 V1
### Reproduction steps
Loaded File, Hit Slice
[Mid Rear-2.zip](https://github.com/Ultimaker/Cura/files/9315…
-
What exactly is this supposed to be?
-
Hi! Thanks for this detailed instruction and your config. I have successfully followed it to install updated firmware.
While installing, I noticed that the process after inserting SD card into the …
-
**Describe the bug**
Follow the readme to install the service on a freshly imaged RPi (with Raspbian) after running `creatlity_install` command no verification code is generated.
Additionally Cre…