-
## Capture notes on the assembly process in an issue as I go.
This can be put into a README.md or other markdown document later.
This content will be good for the Hardware X article.
Note: These …
-
Thanks for publishing this code, and to the previous authors. Not sure if this is related to the issue that you had but I had some major stability issues with the following line:
```
Serial.println(…
-
I have this controller working well on my Solar battery heater application. I use it with a Pwm dimmer to control the heating pads and I use a temp sensor from the battery BMS software that is expose…
-
Installed the custom repository. Then when trying to install the interface I am getting an unexpected error. Have been trying to figure out the issue but not obvious (I am low level). Here is a lin…
-
Are you using the stock buildbotics based controller? If yes, what at all has been modified?
-
The focus seems to have been lost on the upgrade of the Kossels' cooling capabilities. This project is actually far from done and needs to be picked up again as soon as #62 is complete!
- [x] design f…
-
Dear @thomasgermain,
I have been using this integration for over two years, but I'm not able to fully understand its operational behavior due to very poor documentation or to lack of knowledge. Sin…
-
**Describe the problem you have/What new integration you would like**
Integration for the Chinese Diesel Heater models using the RF remote control
**Please describe your use case for this inte…
-
**Describe the bug**
Issues with the integration, throwing an excessive amount of errors, eventually causing RAM usage to cap, and CPU usage to Spike.
First error was a async_forward_entry_setup (…
-
Hellow!
I have arduino due + ramps fd V1.
I can compile marlin 2.0 and all works fine.
SD card work.
But I cant save eeprom on sd card.
Helm me please.
My config:
```cpp
//
// EEPROM
//
…