-
I ran the following command on my raspberry pi (Ubuntu powered):
`sudo npm run getrobotpwd 192.168.x.xxx`
I get to the part where the instructions tell me to hold the "home" button until I hear …
-
The Braava Jet M6 shows all Accessories as "Not Responding" regardless of "Auto Refresh Enabled" state in the configuration.
### Expected Behavior
All Accessories associated with the Braava do not…
-
### Expected Behavior
HomeKit shows current status
### Current Behavior
Since upgrading to version v1.2.0 my Roomba i7 reports "No Response" in HomeKit. If i click on the notification it ty…
-
Hi,
would i be possible to move this Messages to Homebridge Debug Mode? In the normal Mode they only spam my log.
[23/03/2021, 23:01:08] [Roomba] Running status requested
[23/03/2021, 23:01:08] […
-
It seems like a bad interference issue when Pi-hole docker installed on the same host machine along with Homebridge docker. Started experience many issues with Homebridge accessories when installed PI…
vsenn updated
2 years ago
-
Is it possible for those with smart maps to create a switch for a specific zone. I.E if you press "Kitchen" Roomba will automatically clean the kitchen area?
Thanks so much
Versions
- **Hom…
-
My M6 constantly have a 'no response' in HomeKit since launching the plugin. My 671 works fine.
### Expected Behavior
For there to be a response in HomeKit.
### Current Behavior
I see th…
-
## Current Behavior
The Roomba i7+ intermittently shows "Not Responding" when the "Auto Refresh Enabled" setting is confuigred within the config. Initially I had some success in activating the i7 f…
-
**Description**
I migrated to v4 yesterday. Eventually the upgrade/migration finished, I assume, because I couldn't see anything any more. It took me a while to figure out how to get back in via the…
-
### Expected Behavior
### Current Behavior
running npm run getrobotpwd 192.168.x.x get the following errors
0 info it worked if it ends with ok
1 verbose cli [
1 verbose cli '/…