-
Can anyone help me to flash the firmware, especially the display.
The documentation is still in progress.
I tryed to upload with VS Code and PlatformIO but the board is in boot loop.
With my test…
-
Integrate ADS1x15 and HX711 libraries for sensor reading
-
Would be good to get functionality like [Filament Scale for octoprint](https://plugins.octoprint.org/plugins/filament_scale/) proivides where you use a HX711-based load cell to read out the current we…
-
Hello,
I think that better implementation than current could be presented. The final scale value from averaged 24-bit signed integers doesn't make sense because of not considered ENOB (effective numb…
ghost updated
2 years ago
-
Hi @bogde,
along the lines of #123, I am also thinking about giving the current implementation for waiting for the HX711 to become ready
https://github.com/bogde/HX711/blob/899dc7c72415078b054c2…
amotl updated
5 years ago
-
Hi guys, I'm using this code to implement one load cell of 1kg in esp32 (channels VSPI), but when I try to use HSPI pins (esp32), the code just doesn't run, so i trying to use both channels of HX711, …
-
Hey! :)
I'm working with HX711 module in my master degree in mechatronics and I've noticed that there is some 'bug' in your library.
When initialising an object HX711 like:`
hx = HX711(dout_pin=…
-
@tinkermax
many thanks for your code, i have upload it to Nodemcu but after this its continues restart itself and not able to connect to network, i have to flash the nodemcu to interrupt the boot lo…
-
I cannot compile my code for the arduino every board. I only included the library to see if it would compile and it does not. Help.
This is the compiler output.
`E:\programata za arduino IDE e tuka\…
-
i'm getting the following error trying to install this library via `circup`
```zsh
~ % circup install adafruit_hx711
Found device at /Volumes/CIRCUITPY, running CircuitPython 9.1.1.
Searching fo…