-
**_Reported by Andrew Boie:_**
We are going to need to debug low-level boot of ESP32. This board supports OpenOCD/flyswatter. See attached document. Enable the "make debugserver" target in the build …
-
Hi iceman,
In issue #125, after you said:
> Try the latest source. I pushed a fix, where waits for the tag to power up a bit before.
it increased reading distance quite alot on my pm3
I upda…
ID-ao updated
6 years ago
-
What's the usage license of the HydraNFC hardware?
-
**_Reported by Andrew Boie:_**
We are going to need to debug low-level boot of ESP32. This board supports OpenOCD/flyswatter. See attached document. Enable the "make debugserver" target in the build …
-
Trying to benchmark SDcard write speeds on STM32F7 Disco with DMA enabled... I found mentions of 3700 kbps somewhere, but I'm not getting even close ! For my application, I would be needing to write t…
-
I have tested vTaskDelay(10 / portTICK_RATE_MS) using the sample (https://github.com/espressif/esp-idf/blob/master/examples/02_blink/main/blink.c) and the result is we obtain 15ms on the IO5 output in…
-
A sample:
http://pastebin.com/Jqz0jGKX
The non-supported command seem to be:
0x05 Write-then-read with no chip select with zero length (This seems like a bug)
0x01 Enter raw SPI mode , display ver…
-
I have just installed latest DSView from
http://www.dreamsourcelab.com/download/DSView(Beta)_v0.931_setup.exe
1) I load an old file trf7970a_nfm_spi_new_fpga_bitstream_ok.dsl all is ok.
See file http…
-
I've just got hold of the HydraBus + HydraNFC hardware, and I've sniffed my first NDEF record read + write.
With the text file, is there any way I can use a graphical tool to visualise the exchanges?…
-
Load and Save configuration including decoder used, channel name and all settings.
As today DSLogic is not usable for multiple protocol tests as we cannot load/save configuration and we shall always r…