-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
Скласти список всіх (важливих) життєвих подій, визначних дат, досягнень, періодів, що дали приємний і неприємний досвід, тощо. В цьому конкретному випадку довгих списків не буває, натомість бувають по…
-
This seems like a low-hanging-fruit feature request
The MK3 mesh bed leveling is quite coarse, it only probes a 3x3 pattern. I had my heatbed exchanged because my old bed has a slight bow right whe…
-
Currently Shaft Power Bus only works on horizontal plane, and due to #1849 ElC cannot distribute power to a full vertical stack either. I would like to have full-stack vertical distribution for purpos…
-
https://i.imgur.com/sxh3mJn.png
Presented: gasoline engine feeding into Induction Generator through a 2x gearbox, resulting in 2048V/32A in the superconducting wire. It is then split with two 16A r…
-
Hi,
it would be nice to have a (lossless) Transformer with infinite limits for current.
I tried a nitrogen and fin cooled tranformer but i can't transform the power of 2 Auroral batteries due to the…
-
Although my printer technically can print fast the inertia from the moving mass is enough to create jerk resulting in rounded rectangles. I've overcome this by printing slow for the perimeters and fas…
-
If you charge a battery with 4 Engines you can't use an induction motor, even with tungsten upgrade, without loss, because the motor will count the 4 engines + the Battery as source.
-
Using gold wire and a turbine putting approximately 850A of power through the wire I charged 2x procyon batteries on that wire that was powering 2x induction motors. When I pulled the battery off the …
-
Following on from the work by @jkriege2 [here](https://github.com/KiCad/kicad-library/issues/1398#issuecomment-313969813)
| Library Name | Description | Previous Name | Notes |
| -----------------…