-
What kind of issue is this?
I have a LOLIN S3 board.
In `platformio.ini file`, when I compile below code using `board = lolin_s3 `and it fails to run/mount LittleFS.
If I simply change `board = l…
-
After enable "CONFIG_SPI_FLASH_ROM_IMPL", failed to mmap model file. Looks like "spi_flash_mmap_get_free_pages" returns free heap size (2944KB is very likely the free heap size at the time) in such ca…
-
In a similar manner as vCPU and v6502, add an interpreter for the 8080 instruction set as suggested by AlanC.
Justification: together with a block device (SDC/MMC), this opens the road to run CP/M …
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
First sorry for the confusion.
Trying to bild for this Panel
(https://www.elecrow.com/esp32-display-5-inch-hmi-display-rgb-tft-lcd-touch-screen-support-lvgl.html)
with ESP32 ESP32-S3-WROOM-1-N4…
-
Cool project !
Looks quiet, too bad...
Had you considered fast parallel SRAM instead ? No RAS/CAS nonsense, 10/15ns grades should be readily available...
I haven't looked at your HDL, do you ta…
-
I'm unfamiliar with how micropython allocates SPIRAM, but my naive assumption is that with 8MB SPIRAM on the N16R8 I would have more than 128K heap?
```
>>> micropython.mem_info()
stack: 736 out of…
-
Hi,
I am trying to flashing the code (builded previously by me on linux machine) on a ESP32-S3 DevKit C and i receive the following error on the serial line:
ESP-ROM:esp32s3-20210327
Build:M…
-
## Environment
- Development Kit: none
- Module or chip used: ESP32-S3
- IDF version: v4.4-144-gafe82b4e1b
- Build System: idf.py
- Compiler version: xtensa-esp32-elf-gcc (crosstool-NG esp-202…
-
### The problem
Trying to connect ESP32-S3-N16R8 to a W5500 Lite module (USR-ES1) also tried a full-sized W5500 also had the same issue just DHCP looking for an address over and over again.
Trie…