-
I'm trying to use a PS3 Eye Camera with opentrack 2023.1.0 and the bundled libusb0 v1.2.6.0 (06/17/2021). As soon as I connect a Dell DA305 USB-C Hub, libusb (and therefore opentrack) can no longer ac…
-
Hi, I'm using an 8GB CM4 with IO board which has 2 CSI connectors. I connected 2 Waveshares OV9281 to it and I'm trying to record 1280x720 8bit video at 120fps from both cameras in parallel. An SSD is…
-
Hey all,
I just found this project the other day after searching for an alternative to Mycroft due to the halt in development. I was running their PiCroft OS on a Raspberry Pi 3B. You boot it up, it …
-
Since I'm still debugging why the mic doesn't respond, it would be helpful to add a note about how to actually access the cli-client in the section where you introduce that.
I tried `./start-mycro…
-
hi i just bought a jetson nano and trying get started with hello world. i am face a problem with the cmake the error is below.
### cmake [options]
cmake [options]
Specify a source directory…
-
I am trying to test the camera node and I have tried to adjust the variables and the gscam examples will launch but everything.lauch and command line launch fails with:
Could not get gstreamer sam…
-
* Before opening a new issue, we wanted to provide you with some useful suggestions (Click "Preview" above for a better view):
* Consider checking out SDK [examples](https://github.com/IntelRea…
-
**Describe the bug**
When I run `libcamera-vid --list-cameras` the camera `ov5647` is detected with the 4 modes:
```
0 : ov5647 [2592x1944] (/base/soc/i2c0mux/i2c@1/ov5647@36)
Modes: 'SGBRG10_…
-
- [x] Basic Connectivity
- [x] Basic Usage
- [x] Expert Usage
- [x] Application Specific Evaluation
-
**Describe the bug**
libcamera-hello reports that no cameras are available
**Bug report**
See attached
**Additional context**
I'm trying to use the Arducam ov7251 with a Raspberry Pi Zero W 2…