-
As described in the Domotica Forum in [this thread](https://www.domoticaforum.eu/viewtopic.php?f=75&t=13520&start=30#p99730) there may occasionally be a problem if the binding sends several commands t…
-
Hi after some testing with the otgw sensor I noticed this value not changing at all. When I apply a TC=19 it gets to roomset point but the override stays 0. Also the condition flow is acting weird on …
-
I flashed latest version (0.8.1).
I decided to do a clean update, so erased the flash, flashed both files of the 0.8.1 using the command from the wiki.
Logged into wifi, configured wifi.
Rebooted…
-
Hi!
I got a version 2.3 OTGW installed between my boiler (Remeha Calenta) and the Toon boiler communication module (ketelmodule). With the latest version (17) I get a pop-up on Toon that there is …
-
### The problem
I am not able to see the status of my MQTT devices, neither with devices connected directly to Mosquitto MQTT broker, nor with Zwave devices connected via the Mosquitto MQTT broker …
-
While trying to enhance the iphone.html remote control for my thermostat such that it would also accept TC commands and have a "Resume Program" button, I noticed that the RoomRemoteOverrideFunctio…
-
Perhaps it is a good idea to have Opentherm Monitor compatability and have OTGW style serial reporting without parsing the Data-ID's. In other words, an option to enable legacy OTGW reporting over Net…
-
Hi,
I did fill by MQTT Home Assistant prefix: domoticz.
when I fill it with domoticz/in some messages are not updated. What is right to do. I can’t use the otgw mqtt plug-in because I have an use…
-
Follow up of issue #84 with OTGW firmware 0.9.1
The DHW enabled bit is now read, but is constantly flipping between 1 and 0.
Use case is still the same.
Setup:
- Thermostat always sets DHW_ENABL…
-
Hi,
I'm having a problem with the OTGW - NodeMCU in combination with Remeha Calenta and Remeha iSense.
I'm using NodeRed /Home assistant to control the remote override setpoint.
All has worked we…