-
Hi,
I performed a Firmware upgrade of my Silicon Labs CP2102N (UZB-7) 700 series controller.
Ever since, all my nodes seem to be dead. Only when a report is triggered from the device, does it se…
-
I have bought a Livolo zigbee switch like this one: https://www.aliexpress.com/item/Livolo-Touch-ZIGBEE/32918552579.html?spm=a2g0v.10010108.1000016%2FB.1.12754ab2JVEKJU
It seems to be a good option…
-
Do we need to use only the dummy sensor with sensor type custom sensor?
Would be nice to have also diagrams besides the graph, with sensor type electric or usage we can generate diagrams.
-
2022-10-16 AlphaCloud V5.0.0.2 New
Signature verification and anti-crawl data functionality are added in all APIs of AlphaCloud.
---- New Request headers---
authsignature: al8e4s2c6c8e91af3e3...…
-
### Todo
- [x] Draw up a plan / specification
- [x] Add nodejs & node-red into Venus OS (done see below; not in master yet)
- [x] Add node-red on/off switch to gui; which starts and stops the nod…
-
This week my internet provider had an issue, killing my cable connection for ~ 10 hours.
After it was back, I noticed that my NR crashed many times due to telegram api not having a connection.
I d…
-
### Bug Description
Suddenly while printing the temperature reporting on both bed and hotend stops updating, it just keeps on the last recorded value and if the value is < target it will keep t…
-
Hi,
I just tried to print a complex gcode and I noticed the print stutters if I compile the code using the Full Graphics display. i stutters the same on USB and SD card printing. If I compile without…
-
Please edit this template and fill out all the information you can (where relevant). Failure to provide essential information can delay the response you receive.
* **I'm submitting a ...**
- […
-
Hi,
Have been looking at how to add mightyboard support recently, as have got access to a Replicator clone - however have run into several issues. Main one is, there is no support for MCP4018 I2C dig…