-
Hi, I've got a `waveshare_epd.epd2in7b_V2` that i'm trying to show a picture on.
when i configure the device for `red` mode using an ini file all I get is red pixels on the display, should it als…
-
RaspberryPi with hat is very big and difficult to cool, so, why don't you think about making board for RPi ComputeModule, or JetsonNano CM with some cooling solutions - it will be very handful. It cou…
-
## Abstract
* I've ran LifeHash on LetheKit's [display](https://www.waveshare.net/w/upload/e/e5/1.54inch_e-paper_V2_Datasheet.pdf) (200x200, W&B). Though I attached it to a Rpi3 and ran the code th…
-
I set up VSMP using an ePaper display that turned out to be a epd7in5_HD rather than the default epd7in5b. I was able to find the correct driver in e-paper/RaspberryPi&JetsonNano/python and edit the…
N317T updated
3 years ago
-
From a fresh image of of the latest version of Raspberry Pi OS Lite from https://www.raspberrypi.org/software/operating-systems/
Previous to this I put two files in the /boot ssh and wpa_supplicant…
-
I keep encountering a problem with the player freezing after a few days (usually around 4 days) of running. It happens no matter which version of the code I use (master or 0.2, or missionfloyd’s pyth…
-
I am trying to run the example `epd_7in5_V2_test.py` for the 7.5" V2 board, getting this error:
```
ubuntu@ubuntu:~/e-Paper/RaspberryPi&JetsonNano/python/examples$ python3 epd_7in5_V2_test.py
Tra…
-
## 目的
RaspberryPiで一度セットアップを行ったOpenCRをJetsonnanoで動かすため、
JetsonnanoからOpenCRにファームウェアをアップロードする
## 現状
ROBOTIS e-manual
https://emanual.robotis.com/docs/en/platform/turtlebot3/opencr_setup/#opencr-setu…
-
**Describe the problem**
I tried to update using bash following the merge of pull request #80 but got an error. See below for the transcript.
**Steps to Reproduce**
pi@raspberrypi:~ $ bash …
-
Review the function calls for the Waveshare device and make sure the omni-epd abstraction uses the right methods, with the right parameters based on the library and example code. Any modifications sho…