-
My longitude is 150 00'00" and does not show up on my FT3D is that because $lon is up to 6 characters and my longitude has more characters?
-
The flashing instructions in the readme are:
> 1. Remove batteries from the sonde
> 2. Connect an ST-LINK v2 programmer dongle [...]
> 3. Unlock the flash protection [...]
These instructions d…
-
### Describe the issue you are experiencing
Describe the issue you are experiencing
received an error stating "Can't update config on enp1s0: device: unknown setting name" when attempting to cahng…
-
Hi i have just reviced my ttgo and managed to flash it, i normaly use a RTL-SDR for ballon opservations but i hope the ttgo will automate ballon opservations for me and allow me to better judge if i w…
-
As stated in https://github.com/projecthorus/radiosonde_auto_rx/wiki/RS----Auto_RX-JSON-Formats the special id TCP001 used as the device_id value in station.cfg should activate the UDP mode of auto_rx…
-
Placeholder issue for adding support for some other sonde types.
Things to do to add a new sonde:
- Confirm it can be detected by rs_detect. May need to add support for the correct return code int…
-
Hi,
I like to Request a payload ID for 9A4AM-4FSK.
Thanks!
9A4AM updated
10 months ago
-
I received RS-11G/iMS-100/RS41 which is on a same balloon.
https://sondehub.org/7135152
https://sondehub.org/2104700
https://sondehub.org/T5050463
I recorded IQ data for every sonde.
Currentl…
-
Hello,
How can we add RS41 board to Arduino IDE?
Thanks
-
Today, I received MEISEI RS-11G in my 1st time.
I could not see the Main page because I was not in front of my PC.
Probarbly Type is MEISEI and ID is RS11G-7135153.
About Sonde List, type is iMS1-0…