-
### The problem
The esp01s cannot drive the S8 CO2 sensor,however, when I swipe to another nodemcu, it can drive normally, and I can confirm that there is no problem with my esp01s. It can write the …
-
### The problem
I running a Senseair Co2 sensor, however for this component I can't seem to apply any filters such as moving average etc. It results in a build error about filters being invalid opt…
-
Found that the same plugin cannot be reused
-
As soon as I add #define P016_P035_Extended_AC to custom.h, I get a compile error:
'StaticJsonDocument' was not declared in this scope
my Custom.h:
```
#ifndef ESPEASY_CUSTOM_H
#define E…
-
### The problem
I'm preparing an ESP32 based sensor as a gift. To that end I've configured it with that person's WiFi credentials. But when I boot the device after changing the credentials the BME2…
-
Hi,
i am using the S8 Senseair Modul connected via TX GPIO 1 (D10) and RX GPIO 3 (D9).
Every Morning after opening window i get CO2 values below 400.
After power off/on, same values.
During the da…
-
After flashing a file compiled using Custom.h, the access point does not appear, the STA mode is turned on.
If you compile the normal version, the access point works
I used esp8266
INIT : Boo…
-
### PROBLEM DESCRIPTION
I use a SenseAir K33 sensor, which delivers CO2, temperature, humitity and dewpoint. I can see all four values on the console line from the sensor, and I also see them on …
-
### The problem
I'm using D1 Mini ESP32. I have 3 UARTs created, one for a SenseAir S8 CO2 sensor, another one for MH-Z19 CO2 sensor and the third one for a PMS7003 PM sensor.
If I remove in the…
-
It would be great if we could change the autoscale behavior. For example one of the following (or all) would be nice:
1. Exclude certain entities from the automatically computed axis limits.
2. …